FORMAT
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of PD IEC/TS 62548:2013 2014This Technical Specification sets out design requirements for photovoltaic (PV) arrays including d.c. array wiring, electrical protection devices, switching and earthing provisions. The scope includes all parts of the PV array up to but not including energy storage devices, power conversion equipment or loads. The object of this Technical Specification is to address the design safety requirements arising from the particular characteristics of photovoltaic systems. Direct current systems, and PV arrays in particular, pose some hazards in addition to those derived from conventional a.c. power systems, including the ability to produce and sustain electrical arcs with currents that are not greater than normal operating currents. In grid connected systems the safety requirements of this Technical Specification are however critically dependent on the inverters associated with PV arrays complying with the requirements of IEC 62109‑1 and IEC 62109‑2 . Installation requirements are also critically dependent on compliance with IEC 60364 series (see Clause 4). PV arrays of less than 100 W and less than 35 V d.c. open circuit voltage at STC are not covered by this Technical Specification. Attention is drawn to Annex D describing arc fault detection and interruption in PV arrays. It is expected that requirements for the use of this type of equipment will be included in this Technical Specification when reliable commercial equipment for detection of arcs in PV systems is available. NOTE 1 This Technical Specification covers the protection requirements of PV arrays which develop as a result of the use of batteries in PV systems. NOTE 2 Additional requirements may be needed for more specialized installations e.g. concentrating systems, tracking systems or building integrated PV.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|