|
FORMAT
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of PD CEN/TS 16637-1:2014 2014(1) This Technical Specification allows the identification of the appropriate leaching test method for the determination of the release of Regulated Dangerous Substances from construction products into soil, surface water and groundwater. This document provides a stepwise procedure for the determination of appropriate release tests, including:
(2) Furthermore, this Technical Specification gives general guidance for CEN Technical Product Committees on basic aspects (sampling, sample preparation and storage, eluate treatment, analysis of eluates and documentation) to be specified in the relevant product standards. (3) Metallic products, coatings on metallic products and organic coatings for metals are not considered in the determination scheme of this Technical Specification since the test method in CEN/TS 16637‑2 (tank test) is not appropriate for the testing of these construction products due to a different release mechanism (solubility control). NOTE Metallic products are excluded from the scope of CEN/TS 16637‑2 because the principles of that test (diffusion) are not obeyed by these products. Metallic products have shown pH dependent solubility control, which means that metals released from the oxidation layer on the metal until the maximum possible solubility level at the prevailing pH conditions in the surrounding water is reached (more water in contact with the same metal surface means more metals released and more time does not lead to more release due to solubility control). Maximum level of release can often be reached in minutes to hours. More generally, it can be stated that expression of results for metallic surfaces in mg/(m2·s) is always “ conditional”, i.e. dependent on the local conditions at which the measurements were done, such as the volume of water relative to the surface area. For impact assessment, it is necessary to understand the above mentioned effects and to capture these effects in a test reflecting the dominant release mechanism. However, such a test method is currently unavailable. If the intrinsic leaching behaviour is known, release under specified local conditions could be determined by modelling. Furthermore, no notified regulations exist for metallic products at the time these Technical Specifications have been published. (4) It is assumed that intermittent contact with water (e.g. exposure to rainwater) is tested - by convention - as permanent contact. For some coatings, (e.g. some renders with organic binders according to EN 15824 ) in intermittent contact to water, physical and chemical properties might be altered in permanent contact with water. These products are not considered in the determination scheme of this Technical Specification since the test method in CEN/TS 16637‑2 is not appropriate for the testing of these construction products.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|