|
FORMAT
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of PAS 2424:2014 2014This PAS specifies a test method for residual bactericidal and/or yeasticidal activity of liquid, chemical disinfectant products that are applied to hard, non-porous surfaces which are likely to undergo abrasive action. The method described is intended to determine the activity of commercial formulations or active substances under the conditions in which they are used in accordance with BS EN 13697:2001 . It has been designed as an extension of BS EN 13697:2001 and is intended to be used in conjunction with this recognized standard allowing BS EN 13697:2001 to assess the initial antimicrobial action of a product and PAS 2424 to assess the residual antimicrobial action. Therefore the results from this PAS will only be considered if the product tested also achieves a pass according to BS EN 13697:2001 (≥4 log reduction) under conditions required for the test product’s application of use (e.g. specified contact times, micro-organisms, organic load, etc.). It is applicable to ready-to-use products or dilute-to-use products that form a homogeneous, physically stable preparation when diluted with hard water. It is applicable to products that are used in areas that are covered in BS EN 13697:2001 . This includes but is not limited to hard surfaces in the food industry, institutional areas such as schools, hospitals and nursing homes, in the workplace and in the home/domestic environment. It is not applicable to thickened or viscous products such as toilet bleaches or gels, wash-off products and products that are permanently bound to a surface. This PAS is designed for laboratories that perform antimicrobial testing in order to test the residual antimicrobial properties of liquid, chemical disinfectant products. NOTE 1 The sticky nature of thickened products and gels make the abrasion regime difficult to perform and therefore could lead to unreliable results. NOTE 2 The testing of wash-off products would require a method with the inclusion of a rinsing step. NOTE 3 Intrinsically antimicrobial surfaces are designed to remain active for longer than the 24 h covered in this test method.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|