ASTM G105-02
Historical Standard: ASTM G105-02 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
SUPERSEDED (see Active link, below)
ASTM G105
1. Scope
1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.
1.2 Abrasion test results are reported as volume loss in cubic millimeters. Materials of higher abrasion resistance will have a lower volume loss.
1.3 Values stated in SI units are to be regarded as the standard. Inch-pound units are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2000 Classification System for Rubber Products in Automotive Applications
D2240 Test Method for Rubber Property--Durometer Hardness
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
G40 Terminology Relating to Wear and Erosion
SAE Standard
SAEJ200 Classification System for Rubber MaterialsKeywords
abrasive wear test; metallic materials; rubber wheel; scratching abrasion; wet sand;
ICS Code
ICS Number Code 83.160.01 (Tyres in general)
DOI: 10.1520/G0105-02
ASTM International is a member of CrossRef.
