ASTM F725-89(1996)
Historical Standard: ASTM F725-89(1996) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
SUPERSEDED (see Active link, below)
ASTM F725
1. Scope
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.
1.2 This practice is applicable to thermoplastic pipe and fittings.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2444 Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
Keywords
drafting impact; drafting impact requirements; impact; plastic pipe; plastic tubing; thermoplastic pipe; thermoplastic tubing; Drafting impact test requirements; Impact resistance--plastics; Impact testing--plastics; Thermoplastic pipe/tube/fittings;
ICS Code
ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
DOI: 10.1520/F0725-89R96
ASTM International is a member of CrossRef.