Significance and Use

This practice is for use by designers and specifiers, regulatory agencies, owners, and inspection organizations who are involved in the rehabilitation of conduits through the use of a resin-impregnated tube inverted through the existing conduit. As for any practice, modifications may be required for specific job conditions.

1. Scope

1.1 This practice describes the procedures for the reconstruction of pipelines and conduits (4 to 108-in. diameter) by the installation of a resin-impregnated, flexible tube which is inverted into the existing conduit by use of a hydrostatic head or air pressure. The resin is cured by circulating hot water or introducing controlled steam within the tube. When cured, the finished pipe will be continuous and tight-fitting. This reconstruction process can be used in a variety of gravity and pressure applications such as sanitary sewers, storm sewers, process piping, electrical conduits, and ventilation systems.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 7.4.2.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents

D638 Test Method for Tensile Properties of Plastics

D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D903 Test Method for Peel or Stripping Strength of Adhesive Bonds

D1600 Terminology for Abbreviated Terms Relating to Plastics

D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

D3839 Guide for Underground Installation of Fiberglass (Glass-FiberReinforced Thermosetting-Resin) Pipe

D5813 Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems

E797 Practice for Measuring Thickness by Manual Ultrasonic Pulse-Echo Contact Method

F412 Terminology Relating to Plastic Piping Systems

AWWA Standard

NASSCO Standard

Keywords

Resin-impregnated tube; Resins; Sewer pipe (thermoplastic); Thermosetting plastic pipe/tubing/fittings; Steel pipe; Styrene; Underground installation--water supply/distribution systems; Water supply/distribution systems; Bypassing; Conduit joining system; Conduits; Curing (in pipeline/conduit rehabilitation); Drainage materials/systems; Drain/waste/vent (DWV)--thermoplastics; Epoxy resin pipe fittings; Epoxy resins; Gravity sewer pipe; Inspection; Inversion; Land drainage piping systems; Nonpressure piping; Polybutylene (PB) pipe; Polyethylene (PE) conduit; Polyethylene (PE) pipe; Poly(vinyl chloride)(PVC) conduits; Pressure pipelines/piping systems; Rehabilitation--sewerlines; Reinforced thermosetting-resin pipe (RTRP);

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F1216-09

ASTM International is a member of CrossRef.

ASTM F1216