ASTM E775-87(1996)
Historical Standard: ASTM E775-87(1996) Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
SUPERSEDED (see Active link, below)
ASTM E775
1. Scope
1.1 These test methods cover two alternative procedures for the determination of total sulfur in prepared analysis samples of solid forms of refuse-derived fuel (RDF). Sulfur is included in the ultimate analysis of RDF.
1.2 The test methods appear in the following order:
Test Sections Eschka Method 8 to 11 Bomb Washing Method 12 to 131.3 These test methods may be applicable to any waste material from which a laboratory analysis sample can be prepared.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
1.5 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 6.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1193 Specification for Reagent Water
D5681 Terminology for Waste and Waste Management
E180 Practice for Determining the Precision of ASTM Methods for Analysis and Testing of Industrial and Specialty Chemicals
E711 Test Method for Gross Calorific Value of Refuse-Derived Fuel by the Bomb Calorimeter
E829 Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis
Keywords
Bomb washing method; Eschka method; Refuse-derived fuel (RDF); Sulfur
ICS Code
ICS Number Code 75.160.10 (Solid fuels)
DOI: 10.1520/E0775-87R96
ASTM International is a member of CrossRef.