ASTM E74-12
Historical Standard: ASTM E74-12 Standard Practice of Calibration of Force-Measuring Instruments for Verifying the Force Indication of Testing Machines
SUPERSEDED (see Active link, below)
ASTM E74
1. Scope
1.1 The purpose of this practice is to specify procedures for the calibration of force-measuring instruments. Procedures are included for the following types of instruments:
1.1.1 Elastic force-measuring instruments, and
1.1.2 Force-multiplying systems, such as balances and small platform scales.
1.2 The values stated in SI units are to be regarded as the standard. Other metric and inch-pound values are regarded as equivalent when required.
1.3 This practice is intended for the calibration of static force measuring instruments. It is not applicable for dynamic or high speed force calibrations, nor can the results of calibrations performed in accordance with this practice be assumed valid for dynamic or high speed force measurements.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E4 Practices for Force Verification of Testing Machines
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
American National Standard
B46.1 Surface Texture Available from American National Standards Institute, 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
force standard; load cell; proving ring; testing machine ;
ICS Code
ICS Number Code 17.100 (Measurement of force, weight and pressure)
DOI: 10.1520/E0074-12
ASTM International is a member of CrossRef.
