ASTM E292-09
Historical Standard: ASTM E292-09 Standard Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials
SUPERSEDED (see Active link, below)
ASTM E292
1. Scope
1.1 These test methods cover the determination of the time for rupture of notched specimens under conditions of constant load and temperature. These test methods also includes the essential requirements for testing equipment.
1.2 The values stated in inch-pound units are to be regarded as the standard. The units in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A453/A453M Specification for High-Temperature Bolting, with Expansion Coefficients Comparable to Austenitic Stainless Steels
E4 Practices for Force Verification of Testing Machines
E6 Terminology Relating to Methods of Mechanical Testing
E8/E8M Test Methods for Tension Testing of Metallic Materials
E74 Practice of Calibration of Force-Measuring Instruments for Verifying the Force Indication of Testing Machines
E139 Test Methods for Conducting Creep, Creep-Rupture, and Stress-Rupture Tests of Metallic Materials
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E220 Test Method for Calibration of Thermocouples By Comparison Techniques
E633 Guide for Use of Thermocouples in Creep and Stress-Rupture Testing to 1800F (1000C) in Air
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
E1012 Practice for Verification of Testing Frame and Specimen Alignment Under Tensile and Compressive Axial Force Application
Military Standard
MIL-STD-120 Gage Inspection Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.Keywords
axiality; bending strain; bending stress; elongation; final notch cross-sectional area; gage length; k t factor; loading; major diameter; minor diameter; notch cross-sectional area; notch root radius; notch rupture strength; stress; stress-rupture; temperature; thermocouple; Metals and metallic materials; Notches; Rupture/rupture strength; Strength; Thickness ;
ICS Code
ICS Number Code 77.040.10 (Mechanical testing of metals)
DOI: 10.1520/E0292-09
ASTM International is a member of CrossRef.
