1. Scope

1.1 This practice covers the determination of thermomechanical fatigue (TMF) properties of materials under uniaxially loaded strain-controlled conditions. A 'thermomechanical' fatigue cycle is here defined as a condition where uniform temperature and strain fields over the specimen gage section are simultaneously varied and independently controlled . This practice is intended to address TMF testing performed in support of such activities as materials research and development, mechanical design, process and quality control, product performance, and failure analysis. While this practice is specific to strain-controlled testing, many sections will provide useful information for force-controlled or stress-controlled TMF testing.

1.2 This practice allows for any maximum and minimum values of temperature and mechanical strain, and temperature-mechanical strain phasing, with the restriction being that such parameters remain cyclically constant throughout the duration of the test. No restrictions are placed on environmental factors such as pressure, humidity, environmental medium, and others, provided that they are controlled throughout the test, do not cause loss of or change in specimen dimensions in time, and are detailed in the data report.

1.3 The use of this practice is limited to specimens and does not cover testing of full-scale components, structures, or consumer products.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E3 Guide for Preparation of Metallographic Specimens

E4 Practices for Force Verification of Testing Machines

E83 Practice for Verification and Classification of Extensometer Systems

E111 Test Method for Youngs Modulus, Tangent Modulus, and Chord Modulus

E112 Test Methods for Determining Average Grain Size

E220 Test Method for Calibration of Thermocouples By Comparison Techniques

E337 Test Method for Measuring Humidity with a Psychrometer (the Measurement of Wet- and Dry-Bulb Temperatures)

E467 Practice for Verification of Constant Amplitude Dynamic Forces in an Axial Fatigue Testing System

E606 Practice for Strain-Controlled Fatigue Testing

E1012 Practice for Verification of Testing Frame and Specimen Alignment Under Tensile and Compressive Axial Force Application

E1823 Terminology Relating to Fatigue and Fracture Testing

Keywords

Strain-controlled testing; Thermomechanical fatigue testing (TMF) ;

ICS Code

ICS Number Code 19.060 (Mechanical testing)

DOI: 10.1520/E2368-04E01

ASTM International is a member of CrossRef.