1. Scope

1.1 This guide provides general tutorial information regarding the fundamental and physical principles of computed radiography (CR), definitions and terminology required to understand the basic CR process. An introduction to some of the limitations that are typically encountered during the establishment of techniques and basic image processing methods are also provided. This guide does not provide specific techniques or acceptance criteria for specific end-user inspection applications. Information presented within this guide may be useful in conjunction with those standards of section 1.2.

1.2 CR techniques for general inspection applications may be found in Practice E 2033 . Technical qualification attributes for CR systems may be found in Practice E 2445 . Criteria for classification of CR system technical performance levels may be found in Practice E 2446 . Reference Images Standard E 2422 contains digital reference acceptance illustrations.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E94 Guide for Radiographic Examination

E746 Practice for Determining Relative Image Quality Response of Industrial Radiographic Imaging Systems

E747 Practice for Design, Manufacture and Material Grouping Classification of Wire Image Quality Indicators (IQI) Used for Radiology

E1025 Practice for Design, Manufacture, and Material Grouping Classification of Hole-Type Image Quality Indicators (IQI) Used for Radiology

E1316 Terminology for Nondestructive Examinations

E1453 Guide for Storage of Magnetic Tape Media that Contains Analog or Digital Radioscopic Data

E2002 Practice for Determining Total Image Unsharpness in Radiology

E2033 Practice for Computed Radiology (Photostimulable Luminescence Method)

E2339 Practice for Digital Imaging and Communication in Nondestructive Evaluation (DICONDE)

E2422 Digital Reference Images for Inspection of Aluminum Castings

E2445 Practice for Qualification and Long-Term Stability of Computed Radiology Systems

E2446 Practice for Classification of Computed Radiology Systems

E2660 Digital Reference Images for Investment Steel Castings for Aerospace Applications

E2669 Digital Reference Images for Titanium Castings

SMPTE Standard

Keywords

computed; contrast; digital; image plate; media; monitor; noise; pixel; radiography; resolution; scanner; Calibration--nondestructive analysis instrumentation; Configuration; CR (computed radiology) imaging systems; Electronic devices/instruments/equipment; Nondestructive evaluation (NDE); PSL (photostimulable luminescence) method; Radiological examination; Radioluminescence;

ICS Code

ICS Number Code 17.180.01 (Optics and optical measurement in general)

DOI: 10.1520/E2007-08

ASTM International is a member of CrossRef.