ASTM E1127-91(1997)
Historical Standard: ASTM E1127-91(1997) Standard Guide for Depth Profiling in Auger Electron Spectroscopy
SUPERSEDED (see Active link, below)
ASTM E1127
1. Scope
1.1 This guide covers procedures used for depth profiling in Auger electron spectroscopy.
1.2 Guidelines are given for depth profiling by the following:
Section Ion Sputtering 6 Angle Lapping and Cross-Sectioning 7 Mechanical Cratering 8 Nondestructive Depth Profiling 91.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E673 Terminology Relating to Surface Analysis
E684 Practice for Approximate Determination of Current Density of Large-Diameter Ion Beams for Sputter Depth Profiling of Solid Surfaces
E827 Practice for Identifying Elements by the Peaks in Auger Electron Spectroscopy
E996 Practice for Reporting Data in Auger Electron Spectroscopy and X-ray Photoelectron Spectroscopy
E1078 Guide for Specimen Preparation and Mounting in Surface Analysis
E1577 Guide for Reporting of Ion Beam Parameters Used in Surface Analysis
E1634 Guide for Performing Sputter Crater Depth Measurements
E1636 Practice for Analytically Describing Depth-Profile and Linescan-Profile Data by an Extended Logistic Function
E1829 Guide for Handling Specimens Prior to Surface Analysis
ISO Standards
ISO/TR 22335: 2007 Surface Chemical Analysis--Depth Profiling--Measurement of Sputtering Rate: Mesh-Replica Method Using a Mechanical Stylus ProfilometerKeywords
angle lapping; angle-resolved AES; Auger electron spectroscopy; ball cratering; compositional depth profiling; cross sectioning; depth profiling; depth resolution; sputter depth profiling; sputtering; thin films; Surface analysis--spectrochemical analysis; Angle lapping and staining technique; Argon atmospheres; Auger electron spectroscopy (AES); Ball cratering; Crater edge profiling; Depth profiling; Gases; Ion sputtering; Noble gas ions; Nondestructive evaluation (NDE); Polishing properties; Sputter depth profiling data; Xenon;
ICS Code
ICS Number Code 71.040.50 (Physicochemical methods of analysis)
DOI: 10.1520/E1127-91R97
ASTM International is a member of CrossRef.
