ASTM E111-97
Historical Standard: ASTM E111-97 Standard Test Method for Young's Modulus, Tangent Modulus, and Chord Modulus
SUPERSEDED (see Active link, below)
ASTM E111
1. Scope
1.1 This test method covers the determination of Young's modulus, tangent modulus, and chord modulus of structural materials. This test method is limited to materials in which and to temperatures and stresses at which creep is negligible compared to the strain produced immediately upon loading and to elastic behavior.
1.2 Because of experimental problems associated with the establishment of the origin of the stress-strain curve described in 8.1, the use of either initial tangent modulus (that is, the slope of the stress-strain curve at the origin) or secant modulus is not recommended and their determination is outside the scope of this test method.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E4 Practices for Force Verification of Testing Machines
E6 Terminology Relating to Methods of Mechanical Testing
E8 Test Methods for Tension Testing of Metallic Materials
E9 Test Methods of Compression Testing of Metallic Materials at Room Temperature
E21 Test Methods for Elevated Temperature Tension Tests of Metallic Materials
E83 Practice for Verification and Classification of Extensometer Systems
E231 Method for Static Determination of Youngs Modulus of Metals at Low and Elevated Temperatures
E1012 Practice for Verification of Testing Frame and Specimen Alignment Under Tensile and Compressive Axial Force Application
Keywords
chord modulus; stress-strain diagram; tangent modulus; Young's modulus; Chord modulus; Stress--metallic materials; Stress-strain testing; Structural metals/alloys; Tangent modulus; Young's modulus;
ICS Code
ICS Number Code 19.060 (Mechanical testing)
DOI: 10.1520/E0111-97
ASTM International is a member of CrossRef.