1. Scope

1.1 These test methods cover procedures for estimating the depth of decarburization of steels irrespective of the composition, matrix microstructure, or section shape. The following basic procedures may be used:

1.1.1 Screening methods.

1.1.2 Microscopical methods.

1.1.3 Microindentation hardness methods.

1.1.4 Chemical analysis methods.

1.2 In case of a dispute, the rigorous quantitative or lineal analysis method (see 7.3.5 and 7.3.6) shall be the referee method. These methods can be employed with any cross-sectional shape. The chemical analytical methods generally reveal a greater depth of decarburization than the microscopical methods but are limited to certain simple shapes and by availability of equipment. These techniques are generally reserved for research studies. The microindentation hardness method is suitable for accurate measurements of hardened structures with relatively homogeneous microstructures.

1.3 The values stated in SI units are to be regarded as standard. The inch-pound equivalents are in parentheses and may be approximate.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys

E3 Guide for Preparation of Metallographic Specimens

E7 Terminology Relating to Metallography

E340 Test Method for Macroetching Metals and Alloys

E350 Test Methods for Chemical Analysis of Carbon Steel, Low-Alloy Steel, Silicon Electrical Steel, Ingot Iron, and Wrought Iron

E384 Test Method for Knoop and Vickers Hardness of Materials

E407 Practice for Microetching Metals and Alloys

E415 Test Method for Atomic Emission Vacuum Spectrometric Analysis of Carbon and Low-Alloy Steel

E1951 Guide for Calibrating Reticles and Light Microscope Magnifications

Keywords

carbon content; complete decarburization; decarburization; ferrite; microindentation hardness; partial decarburization; steels; total decarburization;

ICS Code

ICS Number Code 77.080.20 (Steels)

DOI: 10.1520/E1077-91R97

ASTM International is a member of CrossRef.