ASTM D7679-10
Historical Standard: ASTM D7679-10 Standard Test Method for Sulfur Content in Carbon Black Feedstock Oils
SUPERSEDED (see Active link, below)
ASTM D7679
1. Scope
1.1 This test method covers the instrumental determination of sulfur content in samples of carbon black feedstock oils. Values obtained represent the total sulfur content.
1.2 This test method is applicable to carbon black feedstock oils derived from petroleum, coal, and other sources which include fuel oils, residues, tars, pitches, reclaimed oils, and similar materials that are normally handled as liquids. This test method is applicable to products typically containing 0 to 5 mass % sulfur.
1.3 The results of these tests can be expressed as mass % sulfur.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1619 Test Methods for Carbon Black--Sulfur Content
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D4177 Practice for Automatic Sampling of Petroleum and Petroleum Products
Keywords
carbon black; combustion; feedstock; hydrocarbon oil; sulfur content;
ICS Code
ICS Number Code 75.080 (Petroleum products in general)
DOI: 10.1520/D7679-10
ASTM International is a member of CrossRef.