ASTM D6778-02
Historical Standard: ASTM D6778-02 Standard Classification for Polyoxymethylene (POM, Acetal) Molding and Extrusion Materials
SUPERSEDED (see Active link, below)
ASTM D6778
1. Scope
1.1 This classification covers polyoxymethylene materials suitable for molding and extrusion. This specification allows for the use of polyoxymethylene plastic materials that are recycled, reconstituted, recycled-regrind, recovered, or reprocessed, or combination thereof, provided that the requirements as stated in this specification are met. It is the responsibility of the supplier and the buyer of recycled, reconstituted, recycled-regrind, recovered, or reprocessed polyoxymethylene plastic materials, or combination thereof, to ensure compliance. (See Guide D 5033).
1.2 The properties included in this classification are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics important to specialized applications. These may be specified by using the suffixes as given in Section 5.
1.3 This classification and subsequent line callout are intended to provide a means of calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection should be made by those having expertise in the field of plastics design after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those covered by this classification.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 The following precautionary caveat pertains only to the test method portion, Section 11, of this classification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
Note 1This classification is similar to ISO 9988-1 and 9988-2, although the technical content is significantly different.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1600 Terminology for Abbreviated Terms Relating to Plastics
D3892 Practice for Packaging/Packing of Plastics
D4000 Classification System for Specifying Plastic Materials
D5630 Test Method for Ash Content in Plastics
D6100 Specification for Extruded, Compression Molded and Injection Molded Polyoxymethylene Shapes (POM)
D7209 Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Keywords
acetal; acetal copolymer; acetal homopolymer; acetal terpolymer; classification; classification system; line callout; L-P-392A; MIL-P-46137A (MR); plastic materials; polyformaldehyde; polyoxymethylene; polyoxymethylene copolymer; polyoxymethylene homopolymer; polyoxymethylene terpolymer; POM; recycle; specification;
ICS Code
ICS Number Code 83.140.01 (Rubber and plastic products in general)
DOI: 10.1520/D6778-02
ASTM International is a member of CrossRef.