1. Scope

1.1 Use this guide in conjunction with Guide D 5730.

1.2 This guide describes special problems to be considered when planning field investigations in cold regions. The primary focus of this guide is presenting the special problems and concerns of site characterization in the cold regions of the world.

1.3 Laboratory testing of soil, rock and ground-water samples is specified by other ASTM standards that are not specifically discussed in this guide. Laboratory methods for measurement of physical properties relevant to environmental investigations are included in Guide D 5730.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This guide emphasizes the care that must be taken by all field personnel during operations in tundra and perma-frost areas of the world.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D653 Terminology Relating to Soil, Rock, and Contained Fluids

D4083 Practice for Description of Frozen Soils (Visual-Manual Procedure)

D5254 Practice for Minimum Set of Data Elements to Identify a Ground-Water Site

D5408 Guide for Set of Data Elements to Describe a Groundwater Site; Part One--Additional Identification Descriptors

D5409 Guide for Set of Data Elements to Describe a Ground-Water Site; Part Two--Physical Descriptors

D5410 Guide for Set of Data Elements to Describe a Ground-Water Site;Part Three--Usage Descriptors

D5730 Guide for Site Characterization for Environmental Purposes With Emphasis on Soil, Rock, the Vadose Zone and Ground Water

D5781 Guide for Use of Dual-Wall Reverse-Circulation Drilling for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices

D5783 Guide for Use of Direct Rotary Drilling with Water-Based Drilling Fluid for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices

D6001 Guide for Direct-Push Ground Water Sampling for Environmental Site Characterization

Keywords

antarctic; arctic; cold regions; drilling; environmental site characterization; groundwater: Cold regions; Environmental site assessment (ESA);

ICS Code

ICS Number Code 19.040 (Environmental testing)

DOI: 10.1520/D5995-98

ASTM International is a member of CrossRef.