ASTM D5949-01e1
Historical Standard: ASTM D5949-01e1 Standard Test Method for Pour Point of Petroleum Products (Automatic Pressure Pulsing Method)
SUPERSEDED (see Active link, below)
ASTM D5949
1. Scope
1.1 This test method covers the determination of pour point of petroleum products by an automatic instrument that applies a controlled burst of nitrogen gas onto the specimen surface while the specimen is being cooled and detects movement of the surface of the test specimen with an optical device.
1.2 This test method is designed to cover the range of temperatures from 57 to +51C. However, the range of temperatures included in the 1992 interlaboratory test program only covered the temperature range from 39 to +6C and the range of temperatures included in the 1998 interlaboratory test program was from 51 to 11C. (see 13.4).
1.3 Test results from this test method can be determined at 1 or 3C testing intervals.
1.4 This test method is not intended for use with crude oils.
Note 1The applicability of this test method or residual fuel samples has not been verified. For further information on applicability, refer to 13.4.
1.5 The values stated in SI units are regarded as standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D97 Test Method for Pour Point of Petroleum Products
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D4177 Practice for Automatic Sampling of Petroleum and Petroleum Products
Energy Institute Standard
IP 15 Test Method for Pour Point of Petroleum Products Available from Energy Institute, 61 New Cavendish St., London, WIG 7AR, U.K., http://www.energyinst.org.uk.Keywords
Peltier; petroleum products; pour point; pressure pulsing; thermoelectric; Automated procedures--petroleum products analysis; Fuel oils; Fuel systems; Instrumental measurement--petroleum products; Lubricating oils; Petroleum products; Pipeline operations; Pour point--petroleum products ;
ICS Code
ICS Number Code 75.080 (Petroleum products in general)
DOI: 10.1520/D5949-01E01
ASTM International is a member of CrossRef.