ASTM D5628-96(2001)e1
Historical Standard: ASTM D5628-96(2001)e1 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
SUPERSEDED (see Active link, below)
ASTM D5628
1. Scope
1.1 This test method covers the determination of the relative ranking of materials according to the energy required to crack or break flat, rigid plastic specimens under various specified conditions of impact of a free-falling dart (tup).
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 8.
Note 1This test method and ISO 6603-1-1985 are technically equivalent only when the test conditions and specimen geometry required for Geometry FE and the Bruceton Staircase method of calculation are used.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ISO Standards
ISO6603-1 Plastics--Determination of Multiaxial Impact Behavior of Rigid Plastics--Part 1: Falling Dart MethodASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D1600 Terminology for Abbreviated Terms Relating to Plastics
D1709 Test Methods for Impact Resistance of Plastic Film by the Free-Falling Dart Method
D2444 Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
D3763 Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
D4000 Classification System for Specifying Plastic Materials
D5947 Test Methods for Physical Dimensions of Solid Plastics Specimens
D6779 Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA)
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
dart impact; falling-mass impact; impact; impact resistance; mean-failure energy; mean-failure height; mean-failure mass; rigid plastic; tup; Dart impact method; Free-falling dart method; Impact testing--plastics; Mean-failure energy/height/weight; Rigid plastics; Tup (falling weight) ;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D5628-96R01E01
ASTM International is a member of CrossRef.
