ASTM D5363-03e1
Historical Standard: ASTM D5363-03e1 Standard Specification for Anaerobic Single-Component Adhesives (AN)
SUPERSEDED (see Active link, below)
ASTM D5363
1. Scope
1.1 This specification covers single-component anaerobic adhesives suitable for locking, sealing, and retaining threaded or cylindrical assemblies. The adhesives are cured to a solid state when confined between closely fitting active metal surfaces.
1.2 This specification is intended to be a means of classifying anaerobic adhesives. It is not intended for engineering design purposes.
1.3 This specification is intended to replace Military Specifications MIL-S-22473, MIL-S-46163, and MIL-R-46082.
1.4 The values stated in SI units are to be regarded as the standard.
The following safety hazards caveat pertains only to the test methods portion, Section , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A109/A109M Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled
B36/B36M Specification for Brass Plate, Sheet, Strip, And Rolled Bar
B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate
B633 Specification for Electrodeposited Coatings of Zinc on Iron and Steel
D56 Test Method for Flash Point by Tag Closed Cup Tester
D439 Specification for Automotive Gasoline
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D770 Specification for Isopropyl Alcohol
D907 Terminology of Adhesives
D1084 Test Methods for Viscosity of Adhesives
D1193 Specification for Reagent Water
D2693 Specification for Ethylene Glycol
D3951 Practice for Commercial Packaging
D4562 Test Method for Shear Strength of Adhesives Using Pin-and-Collar Specimen
D4800 Guide for Classifying and Specifying Adhesives
D5648 Test Method for Torque-Tension Relationship of Adhesives Used on Threaded Fasteners (Lubricity)
D5649 Test Method for Torque Strength of Adhesives Used on Threaded Fasteners
D5657 Test Method for Fluid Tightness Ability of Adhesives Used on Threaded Fasteners
E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process
Military Standards
MIL-STD-118 Commercial Packaging of Supplies and EquipmentFederal Standards
FED-STD-313 Material Safety Data Sheets, Preparation and Submission ofFederal Specifications
QQ-P-416 Plating, Cadmium, ElectrodepositedKeywords
adhesive; anaerobic; line callout; Adhesives--specifications; Anaerobic (AN) adhesives; Line call-out specifications;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D5363-03E01
ASTM International is a member of CrossRef.