ASTM D3895-04
Historical Standard: ASTM D3895-04 Standard Test Method for Oxidative-Induction Time of Polyolefins by Differential Scanning Calorimetry
SUPERSEDED (see Active link, below)
ASTM D3895
1. Scope
1.1 This test method outlines a procedure for the determination of oxidative-induction time (OIT) of polymeric materials by differential scanning calorimetry (DSC). It is applicable to polyolefin resins that are in a fully stabilized/compounded form.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards information is given in Section 8.
Note 1This test method is similar to ISO 11357-6, but not equivalent. ISO procedure provides additional information not supplied by this test method.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets
E473 Terminology Relating to Thermal Analysis and Rheology
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
E967 Test Method for Temperature Calibration of Differential Scanning Calorimeters and Differential Thermal Analyzers
Keywords
differential scanning calorimetry; oxidative induction time; polyolefins;
ICS Code
ICS Number Code 83.080.20 (Thermoplastic materials)
DOI: 10.1520/D3895-04
ASTM International is a member of CrossRef.