ASTM D2713-91(2001)
Historical Standard: ASTM D2713-91(2001) Standard Test Method for Dryness of Propane (Valve Freeze Method)
SUPERSEDED (see Active link, below)
ASTM D2713
1. Scope
1.1 This test method covers the measurement of the dryness of propane-type products such as, but not limited to, commercial propane (see Specification D1835).
Note 1--This test method is not applicable to propane-type products containing antifreeze agents. However, the relative freeze times of such materials tested by this procedure may be an indication of the tendency of these products to cause freezing in pressure reducing regulators.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1265 Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method
D1835 Specification for Liquefied Petroleum (LP) Gases
Keywords
dryness; freeze valve; propane; water; Dryness; Propane; Valve freeze method
ICS Code
ICS Number Code 71.100.20 (Gases for industrial application)
DOI: 10.1520/D2713-91R01
ASTM International is a member of CrossRef.
