ASTM D2463-10a
Historical Standard: ASTM D2463-10a Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers
SUPERSEDED (see Active link, below)
ASTM D2463
1. Scope
1.1 This test method provides measures of the drop impact resistance of blow-molded thermoplastic containers as a summation of the effects of material, manufacturing conditions, container design, and perhaps other factors.
1.2 Three procedures are provided as follows:
1.2.1 Procedure A, Static Drop Height Method This procedure is particularly useful for quality control since it is quick.
1.2.2 Procedure B, Bruceton Staircase Method This procedure is used to determine the mean failure height and the standard deviation of the distribution.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.
Note 1There is no known ISO equivalent to this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B177 Guide for Engineering Chromium Electroplating
D883 Terminology Relating to Plastics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
blow-molded containers; drop impact; plastic containers; Blow-molded thermoplastic containers; Drop impact test; Impact resistance--plastics; Plastic bottles; Thermoplastic containers;
ICS Code
ICS Number Code 83.080.20 (Thermoplastic materials); 83.140.99 (Other rubber and plastic products)
DOI: 10.1520/D2463-10A
ASTM International is a member of CrossRef.
