ASTM D1603-94
Historical Standard: ASTM D1603-94 Standard Test Method for Carbon Black In Olefin Plastics
SUPERSEDED (see Active link, below)
ASTM D1603
1. Scope
1.1 This test method covers the determination of the carbon black content in polyethylene, polypropylene, and polybutylene plastics. Its use with acrylic or other polar monomer modifications which might affect the accuracy is not recommended. Determinations of carbon black are made gravimetrically after pyrolysis of the sample under nitrogen. This test method is not applicable to compositions that contain nonvolatile pigments or fillers other than carbon black.
1.1.1 This test method is not applicable to materials containing brominated flame retardant additives at the end.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1--This test method is similar to ISO 6964-1986(E) in title only. The technical content is significantly different.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D883 Terminology Relating to Plastics
D4218 Test Method for Determination of Carbon Black Content in Polyethylene Compounds By the Muffle-Furnace Technique
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO Standard
ISO6964-1986(E) Polyolefin Pipes and Fittings--Determination of Carbon Black by Calcination and Pyrolysis--Test Method and Basic Specification ISO/IEC Selected Standards for Testing Plastics, Second Edition, published by ASTM. Also available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
carbon black; content; gravimetric; plastics; polyolefins; Carbon black content; Ethylene plastics; Olefin plastics; Polybutylene (PB); Polyethylene (PE); Polyolefin (PO); Polypropylene (PP)
ICS Code
ICS Number Code 83.080.10 (Thermosetting materials)
DOI: 10.1520/D1603-94
ASTM International is a member of CrossRef.
