ASTM D1510-06a
Historical Standard: ASTM D1510-06a Standard Test Method for Carbon Black-Iodine Adsorption Number
SUPERSEDED (see Active link, below)
ASTM D1510
1. Scope
1.1 This test method covers the determination of the iodine adsorption number of carbon black.
1.1.1 Procedure A is the original procedure for this determination.
1.1.2 Procedure B specifies an increased sample mass of carbon black and volume of iodine solution (the ratio is the same as in Procedure A) which results in a simplified formula for the calculation of the iodine number.
1.2 The iodine adsorption number of carbon black has been shown to decrease with sample aging. New SRB HT Iodine Standards have been produced that exhibit stable iodine number upon aging. These SRB HT Iodine Standards are recommended for daily monitoring (x-charts) of testing and for standardization of iodine testing (see Section ) when target values cannot be obtained.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1799 Practice for Carbon Black--Sampling Packaged Shipments
D1900 Practice for Carbon Black--Sampling Bulk Shipments
D4483 Practice for Evaluating Precision for Test Method Standards in the Rubber and Carbon Black Manufacturing Industries
D4821 Guide for Carbon Black--Validation of Test Method Precision and Bias
Keywords
carbon black; iodine adsorption number ;
ICS Code
ICS Number Code 83.040.20 (Rubber compounding ingredients)
DOI: 10.1520/D1510-06A
ASTM International is a member of CrossRef.
