ASTM D1183-96e1
Historical Standard: ASTM D1183-96e1 Standard Test Methods for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
SUPERSEDED (see Active link, below)
ASTM D1183
1. Scope
1.1 These test methods cover the determination of the resistance of adhesives to cyclic accelerated service conditions by exposing bonded specimens to conditions of high and low temperatures and high and low relative humilities. The extent of degradation is determined from changes in strength properties as a result of exposure to the test conditions (Note 1). It is recognized that no accelerated procedure for degrading materials correlates perfectly with actual service conditions, and that no single or small group of laboratory test conditions will simulate all actual service conditions. Consequently, care must be exercised in the interpretation and use of data obtained in this test method. The test procedure, the number of cycles of the test procedure to be used, the particular strength property to be used to determine the extent of degradation, and whether test specimens or test panels are to be used, shall be specified in the material specification.
Note 1-These test methods are intended for use with specimens described in the approved ASTM strength test methods for adhesives as follows: Test Methods D 897, D 903, D 906, D 950, D 1002, D 1062, and Method D 1344.1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D897 Test Method for Tensile Properties of Adhesive Bonds
D903 Test Method for Peel or Stripping Strength of Adhesive Bonds
D906 Test Method for Strength Properties of Adhesives in Plywood Type Construction in Shear by Tension Loading
D907 Terminology of Adhesives
D950 Test Method for Impact Strength of Adhesive Bonds
D1002 Test Method for Apparent Shear Strength of Single-Lap-Joint Adhesively Bonded Metal Specimens by Tension Loading (Metal-to-Metal)
D1062 Test Method for Cleavage Strength of Metal-to-Metal Adhesive Bonds
D1141 Practice for the Preparation of Substitute Ocean Water
D1344 Test Method for Testing Cross-Lap Specimens for Tensile Properties of Adhesives
Keywords
adhesives; humidity; laboratory aging; temperature; test conditions; Accelerated aging/testing--adhesives; Adhesives; Bond strength--adhesives; Cyclic exposure testing; Degradation--adhesives; Humidity; Laboratory aging/weathering; Strength--adhesives; Temperature tests--adhesives;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D1183-96E01
ASTM International is a member of CrossRef.