ASTM C1639-07
Historical Standard: ASTM C1639-07 Standard Specification for Fabrication of Cellular Glass Pipe and Tubing Insulation
SUPERSEDED (see Active link, below)
ASTM C1639
1. Scope
1.1 This specification covers fabrication techniques for cellular glass block into billets to fabricate pipe and tubing insulation. All materials shall be in accordance with Specification C 552.
1.2 The purpose of this specification is to optimize the thermal performance of installed cellular glass insulation systems. This is best achieved by limiting the number of joints, in particular through joints.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in the parentheses are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C168 Terminology Relating to Thermal Insulation
C450 Practice for Fabrication of Thermal Insulating Fitting Covers for NPS Piping, and Vessel Lagging
C552 Specification for Cellular Glass Thermal Insulation
C585 Practice for Inner and Outer Diameters of Thermal Insulation for Nominal Sizes of Pipe and Tubing
D312 Specification for Asphalt Used in Roofing
Keywords
cellular glass; fabrication ; pipe insulation tubing, insulation Fabrication; Cellular glass block/pipe thermal insulation;
ICS Code
ICS Number Code 23.040.99 (Other pipeline components); 81.040.30 (Glass products)
DOI: 10.1520/C1639-07
ASTM International is a member of CrossRef.
