ASTM C1407-98(2005)
Historical Standard: ASTM C1407-98(2005) Standard Practice for Calculating Areas, Volume, and Linear Change of Refractory Shapes
SUPERSEDED (see Active link, below)
ASTM C1407
1. Scope
1.1 This practice covers the methods of calculating areas, volumes and linear changes of irregularly shaped refractory specimens.
1.2 Areas of irregular (both conventional and shaped) specimens are required for determining the creep of certain refractory products.
1.3 Linear and volume changes or irregularly shaped refractories are required for determining reheat change.
1.4 The values stated in SI units are to be regarded as the standard
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C20 Test Methods for Apparent Porosity, Water Absorption, Apparent Specific Gravity, and Bulk Density of Burned Refractory Brick and Shapes by Boiling Water
C830 Test Methods for Apparent Porosity, Liquid Absorption, Apparent Specific Gravity, and Bulk Density of Refractory Shapes by Vacuum Pressure
Keywords
area; checkers; creep; Fireclay nozzle; Fireclay sleeves; irregular shapes; linear change; refractories; reheat change; volume; volume change: Area; Linear changes/linearity; Refractories (bricks and shapes); Volumetric measurement--refractories;
ICS Code
ICS Number Code 81.080 (Refractories)
DOI: 10.1520/C1407-98R05
ASTM International is a member of CrossRef.
