ASTM A592/A592M-04
Historical Standard: ASTM A592/A592M-04 Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Fittings and Parts for Pressure Vessels
SUPERSEDED (see Active link, below)
ASTM A592 / A592M
1. Scope
1.1 This specification covers high-strength quenched and tempered low-alloy steel forged fittings and parts for pressure vessels. The maximum thickness of forgings under this specification shall be 11/2 in. [38 mm] for Grade A, and 4 in. [100 mm] for Grades E and F.
Note 1These grades are similar to corresponding grades in Specification A 517/A 517M.
1.2 Although no provision is made for supplementary requirements in this standard, the supplementary requirements in Specification A 788 may be considered by the purchaser.
1.3 Welding technique is of fundamental importance and it is presupposed that welding procedures will be in accordance with approved methods for the class of material used.
1.4 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as the standard; within the text and tables, the SI units are shown in [brackets]. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 Unless the order specifies the applicable 'M' specification designation, the material shall be furnished to the inch-pound units.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A517/A517M Specification for Pressure Vessel Plates, Alloy Steel, High-Strength, Quenched and Tempered
A788/A788M Specification for Steel Forgings, General Requirements
E112 Test Methods for Determining Average Grain Size
Keywords
high-strength low-alloy steel; pressure vessel service; quenched and tempered steel; steel forgings alloy; Carbon steel forgings--specifications; Pressure vessel steel forgings--specifications; Steel fittings--specifications;
ICS Code
ICS Number Code 23.060.01 (Valves in general)
DOI: 10.1520/A0592_A0592M-04
ASTM International is a member of CrossRef.
