ASTM A522/A522M-95b(2001)
Historical Standard: ASTM A522/A522M-95b(2001) Standard Specification for Forged or Rolled 8 and 9% Nickel Alloy Steel Flanges, Fittings, Valves, and Parts for Low-Temperature Service
SUPERSEDED (see Active link, below)
ASTM A522 / A522M
1. Scope
1.1 This specification covers 8 and 9 % nickel-alloy steel forged or rolled flanges, fittings, valves, and parts intended for use in welded pressure vessels for low-temperature service. The specification is applicable to forgings with maximum section thickness of 3 in. [75 mm] in the double normalized and tempered condition and 5 in. [125 mm] in the quenched and tempered condition. Forgings under this specification are intended for service at operating temperatures not lower than -320 o F [-196 o C] for Type I or -275 o F [-170 o C] for Type II or higher than 250 o F [ o 121C].
1.2 Material under this specification is available in two types having different chemical compositions as follows:
| Type | Nominal Nickel Content, % |
| I | 9 |
| II | 8 |
1.3 This specification is expressed in both inch-pound units and SI units. However, unless the order specifies the applicable 'M' specification designation (SI units), the material shall be furnished to inch-pound units.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A788/A788M Specification for Steel Forgings, General Requirements
A961/A961M Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications
Keywords
low temperature applications; nickel alloy steel; pipe fittings; steel; piping applications; pressure containing parts; steel flanges; steel forgings; alloy; steel valves; Pressure vessel steel; Steel fittings--specifications; Nickel alloy flanges/fittings/valves/parts--specifications;
ICS Code
ICS Number Code 23.040.40 (Metal fittings)
DOI: 10.1520/A0522_A0522M-95BR01
ASTM International is a member of CrossRef.
