Already a subscriber?
MADCAD.com Free Trial
Sign up for a 3 day free trial to explore the MADCAD.com interface, PLUS access the
2009 International Building Code to see how it all works.
If you like to setup a quick demo, let us know at support@madcad.com
or +1 800.798.9296 and we will be happy to schedule a webinar for you.
Security check
Please login to your personal account to use this feature.
Please login to your authorized staff account to use this feature.
Are you sure you want to empty the cart?
AWWA C153-19 Ductile-Iron Compact Fittings, 2019
- V. Comments. If you have any comments or questions about this standard, please call AWWA Engineering and Technical Services at 303.794.7711, FAX at 303.795.7603, write to the department at 6666 West Quincy Avenue, Denver, CO 80235-3098, or e-mail at stand
- IV. Major Revisions. The major revisions in this edition of ANSI/AWWA C153/A21.53 are as follows:
- II.C. Connecting Fittings and Aged Cast-iron Pipe. Fittings should be connected carefully to aged existing cast-iron pipe. The outside diameter of aged pipe should be measured before cutting because some older pipe was manufactured to a larger diameter th
- II.D. Advisory Information on Product Testing. The standard acceptance test for static castings is a tensile test from a coupon cast from the same iron. This is typically done with a separately cast ASTM A536 keel block, a modified keel block, or a Y-bloc [Go to Page]
- II.E. Advisory Information for the Purchaser and Specifier. Purchasers and specifiers should be aware that although products may be available that meet the intent of this standard, they may vary in dimensions, characteristics, material properties, or othe
- II.F. Chlorine and Chloramine Degradation of Elastomers. The selection of materials is critical for water service and distribution piping in locations where there is a possibility that elastomers will be in contact with chlorine or chloramines. Documented
- III. Use of This Standard. It is the responsibility of the user of an AWWA standard to determine that the products described in that standard are suitable for use in the particular application being considered. [Go to Page]
- III.A. Purchaser Options and Alternatives. The following items should be provided by the purchaser: [Go to Page]
- III.B. Modification to Standard. Any modification of the provisions, definitions, or terminology in this standard must be provided by the purchaser.
- AWWA Standard
- SECTION 1: GENERAL
- Sec. 1.1 Scope
- Sec. 1.2 Purpose
- Sec. 1.3 Application
- SECTION 1: REFERENCES
- SECTION 1: DEFINITIONS
- SECTION 1: REQUIREMENTS
- Sec. 4.1 Materials
- Sec. 4.2 Permeation
- Sec. 4.3 General Requirements
- Sec. 4.4 Coatings and Linings
- Sec. 4.5 Tolerances or Permitted Variations
- Sec. 4.6 Markings on Fittings
- Sec. 4.7 Special Requirements for Flanged Fittings
- SECTION 5: VERIFICATION
- Sec. 5.1 Inspection
- Sec. 5.2 Test Procedures
- Sec. 5.4 Additional Tests Required by Purchaser
- Sec. 5.5 Performance Requirements
- Sec. 5.6 Defective Specimens and Retests
- Sec. 5.7 Nonconforming Fittings
- SECTION 6: DELIVERY [Go to Page]