Abstract

This practice covers the sampling, for the determination of chemical composition of nonferrous metals and alloys that have been reduced to their final form by mechanical working; that is, by such means as rolling, drawing, and extruding. The portion selection, sample preparation, sampling details, sample size and storage, and resampling are also detailed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This practice covers the sampling, for the determination of chemical composition (Note 1), of nonferrous metals and alloys that have been reduced to their final form by mechanical working; that is, by such means as rolling, drawing, and extruding.

1.1.1 Refer to Practice E255 for copper and copper alloys.

Note 1The selection of correct portions of material and the preparation of a representative sample from such portions are necessary prerequisites to every analysis, the analysis being of no value unless the sample actually represents the average composition of the material from which it was selected.

1.2 In special cases, when agreed upon by the purchaser and the manufacturer, the heat analysis may be accepted as representative of the composition of the finished product. In such cases, the identity of each heat of metal should be maintained through each stage of the manufacturing process to the final form. This method of sampling is not intended to apply under these conditions.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

E135 Terminology Relating to Analytical Chemistry for Metals, Ores, and Related Materials

E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

Keywords

alloys; sampling; wrought nonferrous metals; Composition analysis--metals/alloys; Nonferrous metals/alloys; Sampling nonferrous metals/alloys;

ICS Code

ICS Number Code 77.040.30 (Chemical analysis of metals)

DOI: 10.1520/E0055-11

ASTM International is a member of CrossRef.

ASTM E55