ASTM D1598-02
Historical Standard: ASTM D1598-02 Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
SUPERSEDED (see Active link, below)
ASTM D1598
1. Scope
1.1 This test method covers the determination of the time-to-failure of both thermoplastic and reinforced thermosetting/resin pipe under constant internal pressure.
1.2 This test method provides a method of characterizing plastics in the form of pipe under the conditions prescribed.
1.3 The values stated in inch-pound units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
D2837 Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products
D2992 Practice for Obtaining Hydrostatic or Pressure Design Basis for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings
D3517 Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pressure Pipe
D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings
Keywords
internal pressure; plastic pipe; time-to-failure; Failure end point--plastics; Hoop stress test; Hydrostatic testing; Long-term hydrostatic strength/pressure; Reinforced thermosetting plastics (RTP); Thermoplastic pipe/tube/fittings; Time-to-failure (TTF);
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/D1598-02
ASTM International is a member of CrossRef.
