Abstract
These test methods cover sampling and testing of non-asbestos fiber-cement flat sheets, roofing shingles, siding shingles, and clapboards. These products may be smooth or surface textured.
The following test methods shall be performed: acceptable quality level; flexural strength; density; dimensional measurements; moisture movement; water absorption; moisture content; water
tightness; freeze/thaw for cladding products; warm water; heat/rainwall structures; heat/rainroof structures; and freeze/thawroofing products.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for
its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 These test methods cover sampling and testing of non-asbestos fiber-cement flat sheets, roofing shingles, siding shingles, and clapboards. These products may be smooth or surface
textured. These test methods are utilized in evaluating products cited in Specifications C1186 , C1225 , C1288 , and C1325 .
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and
are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate
safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C20 Test Methods for Apparent Porosity, Water Absorption, Apparent Specific Gravity, and Bulk Density of Burned Refractory Brick and Shapes by Boiling Water
C1154 Terminology for Non-Asbestos Fiber-Reinforced Cement Products
C1186 Specification for Flat Fiber-Cement Sheets
C1225 Specification for Fiber-Cement Roofing Shingles, Shakes, and Slates
C1288 Specification for Discrete Non-Asbestos Fiber-Cement Interior Substrate Sheets
C1325 Specification for Non-Asbestos Fiber-Mat Reinforced Cementitious Backer Units
ISO Standards
ISO3951 Sampling Procedures and Charts for Inspection by Variables for Percent Nonconforming
Keywords
accelerated aging; acceptable quality limit (AQL); cellulose fiber; clapboards; cracking; delamination; density; dimensional measurements; edge straightness measurement; equilibrium
conditioning; flat sheet; flexural; freeze/thaw; granulated surface; heat/rain; inspection by attributes; inspection by variables; length measurement; linear change; long-term chemical
interaction; modulus of rupture; moisture content; moisture movement; non-asbestos fiber cement; polyethylene fiber; polyvinyl alcohol fiber; radiant heat; roofing; sample conditioning;
sample testing; sampling; sampling by attributes; sampling by variables; sampling schemes; saturated conditioning; serviceability; shakes; shingles; siding; slates; smooth surface; squareness
measurement; strength; textured surface; thickness measurement; warm water; water absorption; water displacement method; water tightness; weather degradation; weathering exposure;
weatherproofing; wet conditioning; width measurement ;
ICS Code
ICS Number Code 91.100.40 (Products in fibre-reinforced cement)
DOI: 10.1520/C1185-08R12
ASTM International is a member of CrossRef.
ASTM C1185